2.5A Green Battery Protection Circuit Module For Overcharge
Specified Types: 1S Li-ion/Li-polymer/LiFePO4 Battery Pack
Place of Origin:Guangdong China (Mainland)
Max. continuous charging current:2.5A
Colour of PCM:Green
Packaging & Delivery :
. Netural labels,Antistatic bag /white box and standard export
. Netural packing/Carton box with less than 10KGS
. Delivery Detail:sample within 3 work days,7~15 days for bulk
Balance voltage for single cell
Balance current for single cell
Current consumption for single cell
Max. continuous charging current
Max. cont. discharging current
Over charge detection voltage
Over charge detection delay time
Over charge release voltage
Over discharge detection voltage
Over discharge detection delay time
Over discharge release voltage
Over current detection voltage
Over current detection current
Detection delay time
Exterior short circuit
Detection delay time
Operating Temperature Range
Storage Temperature Range
1). Green product
2). One year warranty
3). Excellent safety performance
4). Short circuit testing passed
5). Overcharge testing passed
6). Over discharge testing passed
7). Original imported material:IC from Japan,MOS from
USA,Components from Sumsang.
8). 1.2m drop testing passed
1). Samples checking: sending by Express ( DHL/UPS/FEDEX/TNT,by
2). Bulk production: sending out by cargo shipping / air freight /
Express(DHL/UPS/FedEx/TNT),or we can accept other shipping terms
according to your requirements.
3). We are not responsible for any accidents, delays or other
issues that are caused by the shipping.
1,Please strictly follow the directions to connect the PCB to the
battery. Usually there’s voltage in the battery at all time, so
operator should connect one single line after other starting from
terminal B, following the order from low voltage to high voltage,
otherwise it can cause irreparable damage.
2,During the installation, pay attention to small metallic
particles that can stick to the protection board.
3,Follow the standard rules when making connections between the
protection board and the lithium-ion battery.Operator should not
run any wire across the back of the protection board. Keep them
along the side of the board instead.
4,When setting up the protection board, be sure to use a hard epoxy
board as an interlayer, to prevent short-circuit caused by the
components on the back of the protection board.
5,Both resistive load and inductive load can be used to test
battery packs that use this PCB, but not electronic load. Testing
with an electronic load will lead to the breakdown of the MOS
components on the protection board.
6,Select proper wire gauge to prevent temperature increase from
high discharge current (when wire gauge is too high) and excessive
voltage drop (when wire gauge is too low).
7,When the PCB is to be installed inside the battery’s housing, the
user must fully take heat/electric insulation and tightness into
account to prevent internal short circuit.
8,Keep any fully charged battery away from children.
9,If any abnormality is detected during use, please stop using the
product immediately and notify professional technician to conduct
inspection and maintenance.